Description
In this video I clean up an old Savage fibreglass hull and fit a Yamaha 25HP two-stroke outboard to make a river commuter boat.
I start by collecting the hull, scraping the old Sikaflex off the transom and washing it with sugar soap. I plug the old holes with epoxy-soaked dowel, then refit the transom board with fresh Sikaflex. With a forklift's help I mount the outboard. The engine and controls had different plug pin counts, so I soldered the wires directly. I adjust the gear selector cable, but the engine still ticks in neutral as the dog clutch touches, and reverse is still poor.
Then I walk through the rest of the work: LED nav lights, a new switch panel, a push-button start and kill switches, the control box, the steering, and a protected stern light that's legal in a commuter zone. I also cover the bilge pump setup and why a water-separating fuel filter is worth fitting. I'm still after the missing Savage badges and some trim.
For outboard and boat repair information, check out my guide: https://guide.dangarmarine.com.au/
If you're enjoying this channel, please consider becoming a channel member at https://www.youtube.com/channel/UCBsXuIe0nBO3Bi2JmtVk1ZQ/join or making a donation at https://www.paypal.me/dangarstu
T-shirts and other merchandise: https://dangar-marine-shop.fourthwall.com/
Tools and parts I use in these videos: https://www.amazon.com/shop/dangarmarine (as an Amazon Associate I earn from qualifying purchases)
Dangar Marine is proudly sponsored by MarineEngine.com, which supplies spare parts for many brands of outboard motors: https://www.marineengine.com/
Music: https://soundcloud.com/dangarstu
