Welcome to YTUnity

One free SpiderTaz Network account works across every network site.

EP3 - Finishing the hull

Dangar Marine Guide 11 months ago

Description

In this video Chabela and I finish preparing and painting the outside of the hull on her old open putt-putt boat, from epoxy primer through to a Bengal Red enamel top coat.

I start by wiping the hull with wax and grease remover, then apply two coats of epoxy primer followed by a sandable barrier undercoat. I sand between coats so the brush doesn't build up the high spots, and I mark the waterline, because the Altex one-part enamel can't be used below it. Where the anti-foul will go I don't fair at all. To find the low spots I spray a light guide coat and sand it back, then spot paint the depressions and bog a few deeper screw holes. We aim for an old boat with a nice finish, not a factory mirror shine. Once the fairing is done, Chabela and I put on the Altex Regatta Gloss Enamel in Bengal Red. Next time we rotate the hull and start on the inside.

For outboard and boat repair information, check out my guide: https://guide.dangarmarine.com.au/

If you're enjoying this channel, please consider becoming a channel member at https://www.youtube.com/channel/UCBsXuIe0nBO3Bi2JmtVk1ZQ/join or making a donation at https://www.paypal.me/dangarstu

T-shirts and other merchandise: https://dangar-marine-shop.fourthwall.com/

Tools and parts I use in these videos: https://www.amazon.com/shop/dangarmarine (as an Amazon Associate I earn from qualifying purchases)

Dangar Marine is proudly sponsored by MarineEngine.com, which supplies spare parts for many brands of outboard motors: https://www.marineengine.com/

Music: https://soundcloud.com/dangarstu

Featured creators

Creators on the SpiderTaz Network

Become a creator →