Description
In this video I get the engine in my boat project cranking and running for the first time, then replace the key ignition switch with a toggle switch and starter button.
First I connect a new battery and leads, work out how the solenoid, ammeter, charge coil and starter wiring fit together, and fit a toggle switch and push button in place of the missing key switch. Along the way I check for fuel at the carburettor, paint the inside of the hull with two-pack epoxy primer, and draw a diagram of how the circuit goes. When I first wire it up the battery shorts to the trigger. The cause is a bare starter terminal touching the wiring, not the wiring inside the box. Once that is sorted, the engine starts with the switch and button. I also cover waterproofing the switch box with Sikaflex and the colour coding of ring terminals. At the end I look at what's next for the hull and engine installation.
For outboard and boat repair information, check out my guide: https://guide.dangarmarine.com.au/
If you're enjoying this channel, please consider becoming a channel member at https://www.youtube.com/channel/UCBsXuIe0nBO3Bi2JmtVk1ZQ/join or making a donation at https://www.paypal.me/dangarstu
T-shirts and other merchandise: https://dangar-marine-shop.fourthwall.com/
Tools and parts I use in these videos: https://www.amazon.com/shop/dangarmarine (as an Amazon Associate I earn from qualifying purchases)
Dangar Marine is proudly sponsored by MarineEngine.com, which supplies spare parts for many brands of outboard motors: https://www.marineengine.com/
Music: https://soundcloud.com/dangarstu
