Description
This 80-year-old Warner & Swasey turret lathe weighs 4,340 lb (1,968 kg). After weighing and turning this massive machine, it was finally time to move it into its permanent position in my trailer machine shop.
The lathe weighs 4,340 lb (1,968 kg). I moved it approximately 20 feet (6 meters), a few inches at a time, using two shop cranes. Then I positioned it under my four-post overhead beam crane and lifted it with two chain hoists.
Before loading the machine, I installed wooden blocks under the trailer suspension to keep the frame from dropping under the weight. I also added weight toward the front using a surface grinder, a wood stove, and other heavy equipment.
After loading the Warner & Swasey onto the rear of the trailer, I backed it up tightly against the newly built workshop platform. A wooden gantry crane was used to unload the lathe, and then I moved it the final few inches at a time with a beam and hoist until it reached its permanent location.
The 4,340-pound Warner & Swasey is finally installed in the workshop!
This video is a visual demonstration of my own project and is not professional rigging instruction. Moving machinery of this weight requires properly rated equipment, stable supports, careful load control, and an understanding of the risks involved.
Which part of the move was the most interesting: moving it with two shop cranes, loading it onto the trailer, or unloading it with the wooden gantry?
#WarnerAndSwasey #LatheMoving #TrailerMachineShop
Этому токарно-револьверному станку Warner & Swasey около 80 лет, а весит он 4,340 фунтов (1,968 кг). После взвешивания и разворота этого огромного станка пришло время окончательно установить его в моей строящейся мастерской.
Станок весит 4,340 фунтов (1,968 кг). С помощью двух шоп-кранов я протащил его примерно на 20 футов (6 метров), передвигая всего по несколько дюймов за один раз. Затем развернул его поперёк под четырёхстоечным балочным краном и поднял двумя цепными лебёдками.
Перед погрузкой я вбил деревянные блоки под рессоры прицепа, чтобы его рама не просела под весом станка. Для распределения нагрузки я также добавил вес в передней части: шлифовальный станок, дровяную печь и другие тяжёлые вещи.
После погрузки Warner & Swasey на заднюю часть прицепа я подогнал прицеп вплотную к построенному помосту. С помощью деревянного П-образного крана станок был выгружен, а затем балкой с лебёдкой я постепенно передвинул его по несколько дюймов на постоянное место.
Warner & Swasey весом 4,340 фунтов наконец установлен в мастерской!
Это видео является демонстрацией моего собственного проекта, а не профессиональной инструкцией по такелажным работам. Для перемещения настолько тяжёлого оборудования необходимы рассчитанные на соответствующую нагрузку приспособления, устойчивые опоры, постоянный контроль груза и понимание всех связанных с этим рисков.
Какая часть перемещения была наиболее интересной: передвижение двумя шоп-кранами, погрузка на прицеп или выгрузка деревянным краном?
